Goro 2000-2

Goro 2000² (Patented)
Heavy Duty Fasteners for Conveyor Belts

Fasteners made of high tensile coated steel (H.T.S.) for high resistance to abrasion.

* Continuous bottom plate to ensure a good alignment of the splice
and easy introduction of the pin.
* Reinforced loops with a constant radius.
* Concealed staples and chamfered edges for protection against hostile effect of belt scrapers.
* Sealing strip available.

Staples pre-mounted in staggered formation, to increase joint strength especially in worn belting. Made of...

* High tensile coated steel (H.T.S.)
* Stainless steel (for Hammer Tool application only).

APLE SIZE No.	Belt Thickness Range		Maximum Working Tension		PIN		Minimum Pulley Diameter
APLE SIZE No.	INCH	mm	PIW	KN./m	INCH	mm	INCH	mm
22	19/64 - 11/32	7.5 - 9	800	140	1/4	6	10	250
24	11/32 - 13/32	9 - 11			9/32	7
26	13/32 - 1/2	11 - 13			9/32	7
28	1/2 - 19/32	13 - 15			9/32	7

Two GORO 20002 Installation Systems (Patented)

for simple and virtually maintenance free operation

GORO 20002 <HMATIC> (Patented) - Utilization with H.T.S. Staples only

* A robust hydraulic machine, using any power source, such as an electric drill, an
air powered impact wrench, etc.
* Belt clamp incorporated
* Open-ended construction allows continuous lacing for wider belts.

The Hammer Tool: T10H/20002-FIX - Patented Utilization with stainless steel staples only

* Easy transportable, simple to operate and maintenance free.
* FIX Hammer Tool is able to install TITAN 10H fasteners and GORO 20002 fasteners in a single operation, with a puch and a hammer.
* Open-ended construction allows continuous lacing for wider belts.