Goro 2000-3

GORO 2000³ (Patented)
Fasteners for Heavy Duty Conveyor Belts

Fasteners made of high tensile coated steel (H.T.S.) or Stainless Steel.

* Continuous bottom plate to ensure good alignment of the joint
and easy introduction of the pin.
* Reinforced loops with a constant radius.
* Concealed staples and chamfered edges for protection against hostile effects of belt scrapers.
* Sealed fasteners available.

Staples pre-mounted in line.

STAPLE SIZE No.	Belt Thickness Range		Maximum Working Tension		PIN		Minimum Pulley Diameter
	INCH	mm	PIW	KN./m	INCH	mm	INCH	mm
29	19/64 - 11/32	7.5 - 9	800	140	1/4	6	10	250
33	11/32 - 13/32	9 - 11			9/32	7

* Made of High tensile coated steel (H.T.S.)
Packaging

* Each box contains 2 strips, sufficient to lace 42" (1050 mm) , 48" (1200 mm), 54" (1350 mm), or 60" (1500 mm) of belting.

Connecting pins not included. Other lengths on request

Two GORO 20003 Installation Systems (patented)
for simple and virtually maintenance free operation

GORO 20003 H-Matic
Robust hydraulic machine, using any power source, such as an electric drill, or an air impact wrench.
Belt clamp incorporated.
Open ended, it allows continuous lacing of wider belts.

Width: 56" (1400 mm). Other lengths on request.

GORO 20003 - FIX: Hammer Tool
The GORO 20003 -FIX hammer tool is used for installation of fasteners with a hammer and punch.
Open ended, the tool allows continuous lacing for wider belts.

Width: 56" (1400 mm). Other lengths on request.